Engineered wood flooring Singapore — multi-layer planks
Engineered wood flooring — a hardwood wear layer bonded over a cross-laminated plywood core. Dimensionally stable in Singapore’s humid climate, with a real-wood top surface. Supplied pre-finished from factory or finished on-site after laying.
What this scope is
Engineered wood planks combine a 2–6 mm hardwood top layer (the wear layer) with a multi-ply plywood core, typically 14–15 mm total thickness. The cross-grain construction resists seasonal movement and is well-suited to tropical conditions and underfloor cooling situations. Most engineered planks are pre-finished — installation is faster and the room is ready to use sooner — but some species are supplied unfinished for site finishing.
Who this is for
- Owners who want a real-wood floor with less seasonal movement.
- Condominium and high-rise units where solid timber may move excessively.
- Projects with tight timelines — pre-finished planks reduce on-site finishing days.
- Spaces with rapid air-conditioning changes (offices, hotels).
Scope of works
- Pre-finished and unfinished engineered planks — oak, walnut, teak top layers.
- Click-lock or glue-down installation as appropriate to the plank system.
- Plywood underlay or direct-to-screed installation depending on plank specification.
- Site survey, moisture reading and quotation.
- Skirting, transitions and threshold strips.
How we run a project
- Site visit, moisture and flatness check, plank system recommendation.
- Quotation with plank brand/series, finish, lead time and total area.
- Material delivery and acclimatisation in the room.
- Subfloor preparation — clean, level and dry.
- Plank installation with manufacturer-specified expansion gaps.
- Final clean and handover with care instructions.
Engineered vs solid timber
Engineered planks move less with humidity, install faster and often cost less than solid hardwood of the same visible species. Solid timber can be refinished many more times. The right choice depends on the room, the budget and how long the floor needs to last before refinishing.
Wear layer and re-coating
A 2 mm wear layer usually allows one careful sanding; 3–6 mm layers allow two or more. Light re-coating without sanding (screen-and-recoat) extends the surface life if the floor is caught before deep scratches penetrate the wear layer.
Things to confirm before fabrication
- Once the wear layer has been sanded to its limit, the plank cannot be refinished further. A typical 2–3 mm wear layer permits one to two careful sandings over its life.
- Engineered planks are still wood — they should not be flooded, and prolonged wet exposure damages the wear layer and the core. Standard wood-floor care applies.
- Underfloor heating compatibility, where applicable, depends on the specific plank system. We refer to the manufacturer technical data sheet on a per-project basis.
